Solartron 70 precision DMMs, but can also be used for general purpose low EMF measurement use. The CBLF-1 is a 1m long test cable using a 4-wire twisted, shielded cable with a 5 pin Fischer connector, intended for the Recommended solution for said application.īesides the standard version (-S) with 10 spades, versions with 10 low EMF gold plated 4mm banana plugs ( -B) or aĬombination thereof ( -SB) with 5 each spades and 4mm-plugs are available (see picture below of version with spades and 4mm connectors).ĬBLF-1: 4-Wire Test Cable with Fischer Connector for Solartron 7081 + 7071 For very high 4-wire ohms measurements the LEC2.2.-1.0 offers even higher insultaion resistance in using one each for the positive and negative signals and is the PTFE as insulation material reduces leakage currents, which is especially important for high-ohms or low current Twisted shielded cable reduces the impact of electrical noise on the measurement. It is a 1m long 4-wire twisted, shielded PTFE cable with gold-plated, crimped copper spades. The LEC1-4-1.0 cable is a low-EMF (electromotive force) cable for low-voltage (SELV), precision measurements where low thermoelectric voltages are To the 4-wire cable (LEC1-4-1.0) shown below.Īlthough the wire used is rated for a much higher voltage, due to its intended use and non-insulated spades we specify this cable for SELV (SafetyĮxtra Low Voltage) voltages up to 42V peak only!īesides the standard version (-S) with 6 spades, versions with 6 low EMF gold plated 4mm banana plugs ( -B) or aĬombination thereof ( -SB) with 3 each spades and 4mm-plugs are available (see picture below of version with 4mm connectors).įor forther details refer to the data sheet below.
.jpg "splice 2 awg18 to 1 awg 18")
Also this cable is the preferred choice for general purpose measurement applications due to its more practical use compared Negative signals and is the recommended solution for said application.
For very high 4-wire ohms measurements this cable offers even higher insulation resistance in using one each for the positive and ETFE as insulation material reduces leakage currents, which is especially important for high-ohms or low current It is a 1m long 2-wire twisted, shielded ETFE cable with gold-plated, crimped copper spades. The LEC2-2-1.0 cable is a low-EMF (electromotive force) cable for low-voltage (SELV), precision measurements where low thermoelectric voltages are In all other cases, EU custromers should order separate wires and cable components listed at the end of this chapter and assemble cables themselves. Please contact us if you have related questions. Unless these are used for an application exempt from the ROHS directive. Therefore complete measurement cables and cable sets cannot be sold to customers within the EU Please note that we do not assure ROHS compliance for our measurement cables.
SPLICE 2 AWG18 TO 1 AWG 18 FULL
Voltages (SELV), usually 42V peak or less, depending on the local regulations, pleae review them prior to use.Ĭustom version of the products listed as well as full custom cables are available on request. Please consult the descriptions/data sheets regarding all technical details of these products.Īll cable products offered here are intended for precision low voltage measurements and due to their uninsulated connectors are intended solely for Secure Extra Low
They enable our customers to get the most out of their test gear. Please see the following chapters below for details:
SPLICE 2 AWG18 TO 1 AWG 18 SERIES
To support precision measurements, we supply a series of preconfigured cable sets as well as components for preceision measurement cables.
0 kommentar(er)
